Rear Window Wiper and Washer Control Switch (Chevrolet Tahoe 2)

1. Remove the instrument cluster trim bezel.

2. Using two slotted screwdrivers, remove the rear window wiper and washer control switch (1) assembly with the fog light switch (2).

3. Disconnect the connector.

4. Install in the reverse order of removal.

[The article is based on data from the website chevyman.ru]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (until 2007)

Removal and installation of the electronic control unit of electrical equipment
Removal and installation the engine oil level sensor
Removal and installation the engine oil pressure sensor
Removal and installation the on-board computer
Replacing bulbs in the instrument cluster

Removal and installation the windshield wiper drive rod
Windshield wiper motor control circuit
Removal and installation windshield wiper arms
Removal and installation windshield wiper blades
Removal and installation the rear window wiper motor

See similar articles on the topic of Chevrolet cars:
Replacing the right front and rear door window lifter control switches Chevrolet Aveo T300 (2012-2018)
Rear window wiper/washer Chevrolet Captiva 1 (2006-2018)
Replacing the electric window control switch unit Chevrolet Cruze 1 (2008-2016)
Windshield wiper and washer circuit (sedan, without rain sensor) Chevrolet Lacetti 1 (2002-2009)
Rear window heating circuit diagram Chevrolet Lanos T150 (2002-2009)
Removal and installation the rear window wiper Chevrolet Niva 1 (2002-2016)
Rear windscreen wiper/washer assembly diagram Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)