Removal and installation windshield wiper arms (Chevrolet Tahoe 2)

1. Open the hood.

2. Unscrew the nut (1) and remove the washer (2). Tightening torque 35 Nm.

3. Turn the washer hose (3) clockwise.

4. Remove the lever (4).

5. Remove the brush (5).

6. Install in the reverse order of removal.

[The original source of the article is the website CHEVYMAN.RU]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (since 2007)

Removal and installation the washer fluid heater
Removal and installation the washer fluid level sensor
Removal and installation the rear window washer electric pump
Removal and installation the windshield washer electric pump
Removal and installation the washer reservoir

Removal and installation the rear window wiper arm
Windshield wiper drive motor control circuit
Windshield wiper drive motor
Rear window wiper drive motor
Removal and installation the windshield wiper drive rod

See similar articles on the topic of Chevrolet cars:
Replacing windshield wiper arms Chevrolet Aveo T300 (2012-2018)
Replacing windshield wiper blades Chevrolet Captiva 1 (2006-2018)
Replacing windshield wiper arms Chevrolet Cruze 1 (2008-2016)
Replacing windshield and tailgate glass wiper blades Chevrolet Lacetti 1 (2002-2009)
Replacing Windshield Wiper Blades Chevrolet Lanos T150 (2002-2009)
Features of the windshield wiper device Chevrolet Niva 1 (2002-2016)
Removal and installation the windshield wiper and washer switch Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)