Input shaft speed sensor (Chevrolet Captiva 1)

Removal procedure

1. Disconnect the cable from the negative terminal of the battery.

2. For HFV6 3.2L or 2.0S Diesel, remove the ECM bracket.

3. Remove the electrical connector (3) of the input shaft speed sensor from the input shaft speed sensor.



4. Remove the primary shaft speed sensor mounting bolt.

5. Remove the input shaft speed sensor from the transmission assembly.

6. Remove the input shaft speed sensor sealing ring. Discard the sealing ring.

Installation procedure

1. Lubricate the O-ring of the input shaft speed sensor with transmission fluid.

2. Install a new input shaft speed sensor O-ring onto the input shaft speed sensor.



3. Install the input shaft speed sensor into the transmission assembly.

4. Install the input shaft speed sensor mounting bolt.

Tighten

Tighten the input shaft speed sensor mounting bolt to 6 Nm (53 lbs.in).



5. Connect the electrical connector (3) to the input shaft speed sensor.

6. For HFV6 3.2L or 2.0S Diesel, install the ECM bracket.

7. Connect the cable to the negative terminal of the battery.



[The original article can be found on the resource: ChevyMan]