Generator bracket — removal and installation (Chevrolet Tahoe 2)

Removal

1. Remove the generator.

2. Remove the power steering pump.

3. Loosen the bolt (3) of the wire bundle support clip, move the clip (1) away from the generator bracket. Tightening torque 9 Nm.

4. Loosen the generator bracket mounting bolts. Tightening torque 50 Nm.

5. Remove the generator bracket.

Installation

6. Installation in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Engine electrical equipment

Generator — removal and installation
Starter — removal and installation
Motor ground cable
Additional battery tray
Battery tray

See similar articles on the topic of Chevrolet cars:
Design Features of the Generator Chevrolet Aveo T300 (2012-2018)
Checking the generator output power Chevrolet Captiva 1 (2006-2018)
Features of the generator design Chevrolet Cruze 1 (2008-2016)
Removal the generator Chevrolet Lacetti 1 (2002-2009)
Removal the generator Chevrolet Lanos T150 (2002-2009)
Removal and installation the steering shaft with bracket Chevrolet Niva 1 (2002-2016)
Removal and installation the generator Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)