Additional battery tray (Chevrolet Tahoe 2)

Removal

1. Unscrew the six bolts securing the additional battery tray. Remember the installation locations of the bolts of different lengths. Tightening torque 9 N·m.

2. Remove the tray.

Installation

3. Installation in reverse order.

[Information taken from the official website: «chevyman.ru»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Engine electrical equipment

Battery tray
Battery current sensor
Battery — Removal and Installation
Battery — General Information
Starter Cable — Removal and Installation

Motor ground cable
Starter — removal and installation
Generator — removal and installation
Generator bracket — removal and installation

See similar articles on the topic of Chevrolet cars:
The battery is not recharging Chevrolet Aveo T300 (2012-2018)
Starting the engine from an additional battery Chevrolet Captiva 1 (2006-2018)
The battery is not recharging Chevrolet Cruze 1 (2008-2016)
Starting the engine from another car's battery («jump-starting») Chevrolet Lacetti 1 (2002-2009)
Starting the engine from another car's battery (jump-starting) Chevrolet Lanos T150 (2002-2009)
Battery Chevrolet Niva 1 (2002-2016)
Check, service and charge the battery (every 3000 miles or 3 months) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)