Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Aveo T300 (2012-2018) Aveo T250 (2006-2011) Aveo T200 (2003-2008)

Removal and installation the brake caliper (Chevrolet Aveo T250)

1. Raise the vehicle.

2. Mark the position of the front wheels relative to the hubs and remove the wheels.

3. Remove the screws (2) securing the brake caliper bracket to the steering knuckle. Tighten to 95 Nm when installing.

4. Remove the brake caliper assembly (1).

4. Remove the brake caliper assembly (1).

5. Installation is carried out in reverse order.

(The original material is located on the website: «CHEVYMAN.RU»)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Aveo T250: Brake system

Next articles

Replacing the front brake pads
Front Disc Brake Specifications
Brake system device (with ABS)
Brake system design (without ABS)
General information about the braking system

Disassembling and assembling the brake caliper
Replacing brake discs
Rear Drum Brake Specifications
Rear Drum Brake Adjustment
Replacing rear brake pads

See similar articles on the topic of Chevrolet cars:
Parking brake Chevrolet Captiva 1 (2006-2018)
Replacing the front wheel brake caliper assembly Chevrolet Cruze 1 (2008-2016)
Checking the fluid level in the brake and clutch hydraulic reservoir Chevrolet Lacetti 1 (2002-2009)
Replacing fluid in hydraulic brake and clutch drives Chevrolet Lanos T150 (2002-2009)
Brake system Chevrolet Niva 1 (2002-2016)
Brake Caliper — Removal and Installation Chevrolet Tahoe 1 (1992-2000)
Removal, repair and installation of disc brake caliper Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.