Ignition switch illumination (Chevrolet Aveo T250)

1. Disconnect the negative battery cable.

2. Remove the lower steering column cover panel by unscrewing the screws.

3. Loosen the lock slot illumination screw and remove the lock slot illumination.

3. Loosen the lock slot illumination screw and remove the lock slot illumination.

4. Disconnect the electrical connector.

5. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Aveo T250: Steering

Windscreen wiper switch
Turn signal switch
Removal and installation the steering wheel
Steering gear diagram
Steering elements of a car

Forgotten Key Indicator
Removal and installation the ignition switch
Removal and installation of the rotating contact joint (RCJ)
Removal and installation the steering rod end
Removal and installation the steering rod

See similar articles on the topic of Chevrolet cars:
Ignition switch positions Chevrolet Captiva 1 (2006-2018)
Ignition switch (lock) Chevrolet Cruze 1 (2008-2016)
Replacing the contact group, immobilizer control unit and ignition switch Chevrolet Lacetti 1 (2002-2009)
Ignition switch (lock) Chevrolet Lanos T150 (2002-2009)
Ignition switch Chevrolet Niva 1 (2002-2016)
Ignition Drum Switch Replacement Chevrolet Tahoe 1 (1992-2000)
Instrument panel and switch illumination Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet