Necessary equipment
- J-23327 Clutch Spring Compressor
- J-23456 Clutch and Booster Pack Remover
- J-45184 Differential Bearing Race Installer
- J-28585 Snap Ring Remover
1. Remove the flange, disc, plates and elastic disc.
- Using J-28585, remove the snap ring.
- Remove 1 flange, 6 discs, 6 plates and 1 elastic disc.
Important: Be careful not to bend the return spring assembly.
2. Remove the return spring assembly.
- Install J-45184 to center of J-23456.
- Install the transaxle housing cover with final drive assembly onto J-45184.
- Using J-23327-1, which is the bridge piece for J-23327, compress the return spring and use pliers to remove the snap ring.
- Remove all tools.
- Remove the return spring assembly.
Caution: When working with compressed air, wear protective glasses to prevent eye injury.
3. Remove the B5 brake piston.
- While pressing the piston by hand, supply compressed air (4 kg/cm?) to the lubrication channel as shown in the figure and remove the piston.
- Remove the sealing rings from the piston.