2. Disconnect the cable from the throttle lever (see photo).
3. Squeeze the latch on the cable housing and remove the cable from the bracket (see photo).
4. Remove the staples and clamps along the cable route.
5. On the transmission, loosen the bolt and remove the flat washer.
6. Pull the cable by the sheath and disconnect the cable from the rod on the transmission (see photo).
7. Remove the cable seal.
8. Installation is carried out in reverse order.
9. With the engine stopped, press and hold the metal regulator lever at the end of the cable on the engine side.
10. Move the slider on the cable sheath until it stops at the cable connection point.
11. Release the regulator lever.
12. Open the damper completely by turning it by the lever.
13. When turning the lever, the slider on the cable sheath should move with clicks towards the lever.
14. Make sure the cable moves freely. Check the cable movement on a warm engine.