Brake fluid level sensor (Chevrolet Tahoe 2)

Removal

1. Disconnect the brake fluid level sensor wiring connector.

2. Using pliers, squeeze the sensor fixing keys (on the opposite side of the master cylinder.

2. Using pliers, squeeze the sensor fixing keys (on the opposite side of the master cylinder.

3. Remove the sensor.

Installation

4. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Brake system

Master brake cylinder
Brake master cylinder reservoir
Filling the master brake cylinder reservoir
Checking the brake pedal pusher
Checking brake pipes and hoses

Brake pedal — removal and installation
Vacuum brake booster
Brake booster check valve and hose
Hydraulic brake booster
Hydraulic brake booster accumulator

See similar articles on the topic of Chevrolet cars:
Checking and adjusting the brake fluid level Chevrolet Aveo T250 (2006-2011)
Brake fluid and clutch fluid Chevrolet Captiva 1 (2006-2018)
Checking the level and adding fluid to the brake master cylinder reservoir Chevrolet Cruze 1 (2008-2016)
Checking the fluid level in the brake and clutch hydraulic reservoir Chevrolet Lacetti 1 (2002-2009)
Checking the fluid level in the windshield washer reservoir Chevrolet Lanos T150 (2002-2009)
Brake system Chevrolet Niva 1 (2002-2016)
Checking the brake fluid level Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)