Withdrawal
1. Remove the oil pan.
2. Remove the front cover.
3. Turn away a bolt and nuts of fastening of an oil receiver. Tightening torque: bolt 12 Nm; nuts 25 Nm.
4. Remove the oil receiver along with the O-ring.
5. Remove the O-ring.
6. Discard the O-ring.
7. Turn away the remained nuts of fastening of a deflector of a cranked shaft.
8. Remove the crankshaft deflector.
9. Turn away bolts (411) oil pump mountings.
10. Remove the oil pump, plug open holes to prevent dirt from entering the lubrication system.
Installation
1. Align the splines of the crankshaft sprocket and the oil pump gears.
2. Install the pump on the sprocket until the pump housing contacts the cylinder block. Tighten the pump mounting bolts. Tightening torque 25 Nm.
3. Further installation is carried out in the reverse order.