Pressure reducing valve — removal and installation (Chevrolet Tahoe 2)

Removal

1. Remove the oil pan.

2. Place the pallet on the workbench.

3. Unscrew the pressure reducing valve (455) and remove the sealing washer. Discard the valve and washer.

3. Unscrew the pressure reducing valve (455) and remove the sealing washer. Discard the valve and…

4. Check the operation of the NEW valve: lightly press on the valve ball (2), the spring in a fully compressed state should sit on the ball.

Installation

5. Install the valve and sealing washer.

Original version of the article on the website: «ChevyMan.ru»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Engine repair

Oil pan — removal and installation
Oil filter adapter
Rear engine cover
Rear crankshaft oil seal
Variable valve timing system

Oil level sensor
Oil pump — removal and installation
Timing chain and sprockets
Camshaft — Removal and Installation
Torque converter drive clutch

See similar articles on the topic of Chevrolet cars:
Reducing pressure in the fuel system Chevrolet Aveo T300 (2012-2018)
Checking oil pressure Chevrolet Captiva 1 (2006-2018)
Oil pressure dropped Chevrolet Cruze 1 (2008-2016)
Removal camshafts and hydraulic valve lifters Chevrolet Lacetti 1 (2002-2009)
Checking the Manifold Absolute Pressure Sensor Chevrolet Lanos T150 (2002-2009)
Cylinder head and valve mechanism Chevrolet Niva 1 (2002-2016)
Removal and installation the oil filter flange and pressure regulator valve Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)