Air Conditioning Compressor Drive Belt Tensioner (Chevrolet Tahoe 2)

Removal and installation

1. Remove the air conditioning compressor drive belt.

2. Loosen the tensioner mounting bolts. Tightening torque 50 Nm.

3. Remove the tensioner.

4. Installation is carried out in reverse order.

Information taken from the official website «CHEVYMAN.RU»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Engine repair

Tensioner for drive belt of attachment units
Idler pulley — removal and installation
Air conditioning compressor drive belt
Attachment drive belt
Cylinder Block Plugs and Sensors — Design Description

Engine Mounts — Check
Removal and installation the left engine mount
Removal and installation the right engine mount
Support brackets (LY6 engine) — removal and installation
Upper engine cover

See similar articles on the topic of Chevrolet cars:
Notes on adjusting the automatic timing belt tensioner Chevrolet Aveo T250 (2006-2011)
Accessory Drive Belt Tensioner Assembly Chevrolet Captiva 1 (2006-2018)
Checking the accessory drive belt Chevrolet Cruze 1 (2008-2016)
Replacing the auxiliary drive belt tensioner roller Chevrolet Lacetti 1 (2002-2009)
Checking the condition and replacing the air conditioning compressor drive belt Chevrolet Lanos T150 (2002-2009)
Adjusting the tension of the water pump drive belt and the power steering pump drive belt Chevrolet Niva 1 (2002-2016)
Inspection and replacement of the drive belt and tensioner Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)