Contents: Early models ↧ Late models ↧
Early models
1. Raise the vehicle.
2. Remove the left wheel.
3. Remove the left wheel arch liner.
4. Remove the front propeller shaft. Caution: Do not lift the engine by placing a jack under the crankshaft pulley or under the oil pan
5. Raise the engine using a screw jack.
6. Unscrew the bolts securing the left support to the bracket. (The right pore is shown, the left support is attached in the same way). Tightening torque 65 Nm.
7. Loosen the left support mounting bolts. Tightening torque 50 Nm.
8. Remove the left engine mount.
9. Installation is carried out in reverse order.
Late models
1. Remove the air filter outlet duct.
2. Remove the front drive axle.
3. Lower the vehicle.
4. Remove the generator bracket.
5. Loosen the bolts (1) securing the left engine support to the frame. Tightening torque 65 Nm.
Note: When installing, tighten the middle bolt first, then the outer bolts.
6. Raise the car halfway and place safety posts under the frame.
7. Remove the left front wheel arch liner.
Caution: Do not raise the engine by placing the jack under the crankshaft pulley or under the oil pan.
8. Place a screw jack under the engine block technological lug (1).
9. Through the wheel arch opening, unscrew the bolts (1) securing the support to the engine. Tightening torque 50 Nm.
10. Raise the engine and remove the support.
11. Installation is carried out in reverse order.
The article was borrowed from the website CHEVYMAN.ru