Dipstick and dipstick guide (Chevrolet Tahoe 2)

Removal

1. Remove the dipstick (418).

2. Loosen the bolt (419) securing the dipstick guide. Tightening torque 25 Nm.

3. Remove the dipstick guide from the engine block.

4. Check the condition of the guide sealing ring.

Dipstick and dipstick guide

Installation

5. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Engine repair

Valve stem seals and springs
Rocker arms and push rods
Valve cover of the right half-block
Left half-block valve cover
Oil manifold (cylinder deactivation system)

Cylinder head — removal and installation
Valve lifters — removal and installation
Crankshaft pulley
Front crankshaft oil seal
Front engine cover

See similar articles on the topic of Chevrolet cars:
Replacing the oil level indicator guide seal Chevrolet Aveo T300 (2012-2018)
Radiator grille guide Chevrolet Captiva 1 (2006-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)