Vehicle course deviation sensor (Chevrolet Tahoe 2)

Removal

1. Remove the passenger seat.

2. Unscrew the two nuts (1) securing the sensor. Tightening torque 7 Nm.

3. If you need to access the sensor, pull back the mat.

4. Disconnect the sensor connector.

5. Remove the sensor from the vehicle.

Installation

6. Installation is carried out in reverse order.

Information taken from the official website: ChevyMan.ru

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Brake system

Traction control switch
Rear wheel speed sensor synchronizing ring
Rear wheel speed sensor
Front wheel speed sensor
Electronic brake control unit

Location of units and parts of the brake system
Disc brakes — specification
Measuring the thickness of the brake disc
Brake disc surface
Measuring Brake Disc Runout

See similar articles on the topic of Chevrolet cars:
Vehicle Passport Data Chevrolet Aveo T300 (2012-2018)
Vehicle Loading Information Chevrolet Captiva 1 (2006-2018)
Vehicle Passport Data Chevrolet Cruze 1 (2008-2016)
Removal the vehicle speed sensor and its drive Chevrolet Lacetti 1 (2002-2009)
Removal the vehicle speed sensor Chevrolet Lanos T150 (2002-2009)
Basics of safe vehicle operation Chevrolet Niva 1 (2002-2016)
Vehicle Speed Sensor (VSS) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)