Traction control switch (Chevrolet Tahoe 2)

Removal

1. Replace the front panel access panel.

2. Disconnect the switch wiring connector.

3. Using a small screwdriver, unfasten the switch clips and remove the switch.

Installation

4. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Brake system

Rear wheel speed sensor synchronizing ring
Rear wheel speed sensor
Front wheel speed sensor
Electronic brake control unit
System pressure modulator valve

Vehicle course deviation sensor
Location of units and parts of the brake system
Disc brakes — specification
Measuring the thickness of the brake disc
Brake disc surface

See similar articles on the topic of Chevrolet cars:
Ventilation system with manual control unit Chevrolet Aveo T300 (2012-2018)
Tailgate Control Switch Chevrolet Captiva 1 (2006-2018)
Replacing the electric window control switch unit Chevrolet Cruze 1 (2008-2016)
Replacing the contact group, immobilizer control unit and ignition switch Chevrolet Lacetti 1 (2002-2009)
Ignition switch (lock) Chevrolet Lanos T150 (2002-2009)
Control lamp block Chevrolet Niva 1 (2002-2016)
Transfer case control switch (models with electric shift mechanism) Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)