Removal
Remove the generator assembly.
- 1. Generator assembly
- 2. Generator pulley mounting nut
- 3. Generator pulley
- 4. Washer
- 5. Front part of the body
- 6 Front bearing
- 7. Stator
- 8. Rotor
- 9. Fan
- 10. Back of the case
- 11. Rectifier block
- 12. Lid
- 13. Voltage regulator, brush holder
Preparatory work
Before directly removing the generator, the following work must be performed:
- disconnect the negative battery terminal;
- disconnect the intake air temperature (IAT) sensor connector;
- remove the mounting clamps and the air intake pipe (see figure T250 3.086);
- remove the battery connector nut from the generator (see fig T250 3.087);
- unscrew the generator bracket mounting screw (see figure T250 3.088);
- remove the auxiliary drive belt;
- unscrew the nut and remove the generator mounting bolt.
Disassembly
Disassemble in the order shown in the figure (see figure T250 3.090).
Assembly
Assembly is carried out in the reverse order of disassembly.
Installation
Installation is carried out in the reverse order of removal.
Tightening torques
| Element of the system | Tightening torque |
| Generator mounting bolt nut | 25 Nm |
| Battery connector fastening nut | 15 Nm |
(The article is reprinted from the website CHEVYMAN.RU)