Contents: Disassembly ↧ Assembly ↧
Disassembly
1. Remove the differential cover mounting screws, differential cover and differential cover gasket.
2. Remove the bearing adjusting ring retainer (see figure T250 4.112).
3. Remove the left bearing adjusting ring (see figure T250 4.113).
4. Unscrew the screws securing the right bearing holder and remove the holder itself.
5. Remove the differential housing from the gearbox housing.
6. Loosen the screws securing the toothed ring gear of the main transmission driven gear.
7. Remove the final drive driven gear from the differential housing.
8. Remove the satellite axle retaining pin.
9. Remove the satellite axle.
10. Remove the satellite gears and washers.
11. Remove the drive shaft gears and thrust washers.
12. Remove both differential bearings.
13. Remove the speedometer drive from the differential case.
Assembly
1. Install the speedometer drive pinion.
2. Install both differential bearings.
3. Install the drive shaft gears and thrust washers into the differential housing.
4. Install the satellites and their washers into the differential housing.
3. Install the drive shaft gears and thrust washers into the differential housing.
4. Install the satellites and their washers into the differential housing.
5. Install the satellite axle into the differential housing.
6. Install the satellite axle retaining pin.
7. Install the final drive driven gear and tighten the mounting screws to a torque of 70 Nm.
8. Install the differential into the gearbox housing.
9. Install the right bearing holder and tighten the mounting screws to 25 Nm.
10. Install the bearing adjusting ring.
11. Adjust the differential bearing tightening.
The original text can be found on the website: ChevyMan.ru