Input shaft device
- 1. Gearbox housing cover
- 2. Bearing housing
- 3. Reverse gear shaft
- 4. Reverse gear
- 5. Washer
- 6. 5th gear drive pinion
- 7. Drive shaft bearing
- 8. Bearing retaining ring
- 9. Primary shaft centering sleeve
- 10. Drive gear block
- 11. Primary (input) shaft
- 12. Primary shaft bearing
Disassembly
1. Loosen the screw at the end of the drive shaft.
2. Remove the retaining ring at the base of the drive gear block.
3. Remove the drive shaft from the drive gear block using a universal puller (see figure T250 4.090).
4. Remove the bearing from the input shaft gear block using a universal puller (see figure T250 4.091).
Assembly
1. Install the bearing on the seat of the input shaft drive gear block.
2 Press the drive shaft into the drive gear block.
3. Install the retaining ring onto the base of the gear block.
4. Tighten the drive shaft screw to 15 Nm.
[The article was reprinted from the website ChevyMan.ru]