Removal the gear shift rod (Chevrolet Aveo T250)

Removal

1. Remove the rod clamp clamp.

2. Release the universal joint clamp.

3. Separate the cardan joint from the manual transmission.

4. Remove the locking shaft pin and disconnect the gearshift drive rod from the rear mounting bracket of the manual transmission.

4. Remove the locking shaft pin and disconnect the gearshift drive rod from the rear mounting…

5. Remove the shift linkage assembly.

Installation

Assemble in the reverse order of disassembly.

Adjust the shift linkage. See "Adjusting the lever mechanism" in this section.

The original text can be found on the website: chevyman.ru

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Aveo T250: Manual gearbox

Removal and installation the speedometer sensor with drive
Removal and installation the gearshift housing
Removal and installation the gear shift lever
Adjusting the gear shift mechanism
Checking the oil level in the manual transmission

Replacing the wheel drive shaft seal
Removal a manual gearbox
Installation of a manual gearbox
Disassembling the manual gearbox D16
Leading (input) shaft — disassembly and assembly