Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Aveo T300 (2012-2018) Aveo T250 (2006-2011) Aveo T200 (2003-2008)

Removal and installation the speedometer sensor with drive (Chevrolet Aveo T250)

Contents: Removal ↧ Installation ↧

Removal

1. Disconnect the speedometer sensor connector.

1. Disconnect the speedometer sensor connector.

2. Loosen the speedometer sensor mounting screw and remove the sensor.

2. Loosen the speedometer sensor mounting screw and remove the sensor.

Installation

1. Lubricate the sealing ring with Vaseline.

2 Install the sensor in place and secure it with the screw, tightening it to a torque of 4 Nm.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Aveo T250: Manual gearbox

Next articles

Removal and installation the gearshift housing
Removal and installation the gear shift lever
Adjusting the gear shift mechanism
Checking the oil level in the manual transmission
Gear shift mechanism

Removal the gear shift rod
Replacing the wheel drive shaft seal
Removal a manual gearbox
Installation of a manual gearbox
Disassembling the manual gearbox D16

See similar articles on the topic of Chevrolet cars:
Speedometer, odometer and tachometer Chevrolet Captiva 1 (2006-2018)
Checking the accessory drive belt Chevrolet Cruze 1 (2008-2016)
Removal the vehicle speed sensor and its drive Chevrolet Lacetti 1 (2002-2009)
Replacing the alternator drive belt Chevrolet Lanos T150 (2002-2009)
Clutch release hydraulic drive Chevrolet Niva 1 (2002-2016)
All-wheel drive lubrication Chevrolet Tahoe 1 (1992-2000)
Removal and installation the camshaft drive chain and sprockets Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.