2. Before checking, slightly remove the distributor cap to avoid damaging it when hanging the engine.
3. Raise the car and place it on stands, then place a jack under the pan and lift the engine, placing a board under the pan.
4. Check the condition of the supports. If delamination or breaks are detected, replace the support.
5. Check the strength of the cushions and the reliability of the support fastenings to the metal base by shaking the support with a crowbar. If there is a noticeable shift in the support, tighten all the fastenings
6. Disconnect the battery from ground. Raise the car and place it on stands.
7. Unscrew the nut and remove the through bolt of the support from the bracket (see photo).
8. Hang the engine, unscrew the bolts securing the support to the cylinder block (on V6 and V8 engines 5.0 and 5.7 liters) or frame mounting bolts (7.4 liter engine) and remove the support.
9. Installation is carried out in the reverse order. Lubricate the threads of the bolts and nuts with a fixing compound.