Note: it is recommended to carry out the removal and installation of the front fenders with the front wheels removed.
Withdrawal
1. Remove mounting screws and dust shield.
2. Turn off screws under facing of a forward bumper.
3. Turn off the screw of fastening of facing of a forward bumper to a wing of the car.
4. Loosen the bolts at the base of the wing.
5. With the front door open, remove the wing screw at the base of the A-pillar.
6. Open the hood and remove the headlamp.
7. Loosen the mounting screws along the top of the wing.
8. Remove the fender.
Installation
Installation is made in an order, the return to removal.
When installing, install the headlight and fender and tighten the fasteners to the following torques:
- fastening screws along the upper part of the wing - 10 Nm;
- wing fastening screw at the base of the front pillar - 8 Nm;
- fastening screw at the base of the wing -10 Nm,
- screw fastening to the front bumper trim - 1.5 Nm;
- fastening screw behind the front bumper trim - 4 Nm;
- screws securing the mudguard - 1.5 Nm.