2. Remove the oil pressure sensor connector.
3. Install the adapter in place of the oil pressure sensor.
4. Connect the pressure gauge to the adapter.
5. Start the engine and check the oil pressure at idle and at an engine temperature of 80°C.
The minimum oil pressure must be 30 kPa (0.3 bar).
6. Stop the engine and remove the oil pressure sensor and adapter.
7. Install the oil pressure sensor and tighten to a torque of 40 Nm.
8. Connect the electrical connector to the oil pressure sensor.
9. Install the right wheel mudguard.
10. Check the oil level and fill with oil up to the "FULL" mark.