Installing the camshaft (Chevrolet Aveo T250)

1. Install the camshaft.

2. Install the camshaft axial lock.

3. Tighten the camshaft axial lock screws to a torque of 10 Nm.

4. Measure the axial runout of the camshaft. It should be 0.09-0.21 mm.

5. Install the ignition coil mounting plate.

6. Secure the ignition coil mounting plate with screws, tightening them to a torque of 10 Nm.

7. Install the ignition coil.

8. Tighten the ignition coil mounting screws to a torque of 10 Nm.

9. Connect the wires to the ignition coil.

10. Connect the ignition coil connector.

11. Install the battery and its shelf.

12. Connect the negative battery cable.

13. Install the camshaft timing pulley.

14. While holding the camshaft firmly in place, install the camshaft timing pulley bolt and tighten it to 45 Nm.

15. Install the follower rollers.

16. Install the valve cover.

17. Tighten the valve cover screws to 9 Nm.

18. Connect the crankcase ventilation hose to the timing cover.

19. Install the timing belt.

[The original source of the article is the website: CHEVYMAN]