2. Place the car on an inspection ditch. Disconnect the wire from the negative terminal of the battery.
3. Remove the front bumper (see "Removal and installation the front bumper").
4. Remove the air intake (see "Replacing the cooling system radiator").
5. Remove the front bumper bracket (see "Replacing the cooling system radiator").
6. Loosen the nut securing the high pressure supply pipe flange to the condenser flange and disconnect the pipe from the condenser.
7. Loosen the nut securing the high pressure outlet pipe flange to the condenser flange and disconnect the pipe from the condenser.
Warnings: Immediately after disconnecting, plug open ends of pipes to prevent dirt and moisture from entering the system.
Pay attention to the sealing rings of the flange connections of the pipelines. When disconnecting the pipelines during repair of the system, the sealing rings must be replaced.
8. Press the upper and lower fasteners securing the condenser to the radiator of the cooling system on the left side...
9. ...and remove the holders. Similarly, remove the holders on the left side and disconnect the condenser and the radiator of the engine cooling system.
10. Disconnect the wiring harness connector from the refrigerant pressure sensor.
11. Remove the condenser by carefully pulling it upwards.
12. Install the condenser in the reverse order of removal.
Warnings: Open the process plugs of the flanges of the new condenser only immediately before connecting the pipelines.
When installing new pipeline flange sealing rings, be sure to lubricate them with air conditioning compressor oil.
13. Fill the air conditioning system with refrigerant at a specialized car air conditioning service center.