Cylinder honing (Chevrolet Tahoe 1)

1. For honing it is recommended to use a "brush" with emery balls (see photo).





2. The honing procedure is as follows.

• 1) Clamp the fixture into the electric drill.
• 2). Lubricate the cylinder surface well with oil, turn on the electric drill and periodically move it up and down in the cylinder. In this case, a structure of thin lines intersecting at an angle of about 60° should form on the surface of the cylinder walls (see photo). During the honing process, lubricate the cylinder surface continuously. Remove the brush only after the drill has completely stopped.

[Information taken from the official website: ChevyMan.ru]