You will need: a 7 mm socket head, a plastic mounting blade, and a flat-blade screwdriver.
1. Remove the front door trim (see "Removal and installation the front door trim").
2. Remove the speaker mounting bolt...
3. ...and, overcoming the resistance of the spring clamps, remove the speaker from the door.
4. Squeeze the latch and disconnect the wiring harness connector from the speaker...
5. ...and remove the speaker from the car.
6. Install the parts in the reverse order of removal.
7. The speaker of the right front door is removed and installed in the same way.
For removal high frequency speakers perform the following operations.
You will need: a plastic mounting spatula, a flat-blade screwdriver.
1. Pry up the top edge of the front pillar trim...
2. ...and detach the trim from the body pillar, overcoming the force of the clamps.
3. Remove the catch at the bottom of the trim from the groove in the instrument panel.
4. Squeeze the retainer and disconnect the wiring harness connector from the tweeter...
5. ...then remove the upper trim of the front pillar.
6. Press the holders...
7. ...and remove the speaker from its socket in the trim.
8. Install the speaker in the reverse order of removal.
9. The right high-frequency speaker is removed and installed in the same way.
Full-range speakers in the rear doors they are removed and installed using the same techniques as the front door wide-range speakers (see above in this subsection).