1. Disconnect the wire from the terminal «minus» battery.
2. Remove expansion tank «Removal and installation of a broad tank»).
3. Press the clamp of the electric fan wiring harness block...
4.... and disconnect the block.
5. Remove the hose connecting the radiator to the expansion tank from the holder on the electric fan housing.
6. Remove the front bumper, see «Removal and installation of a forward bumper»).
7. On a car with an automatic transmission, remove the upper tube of the automatic transmission heat exchanger from the upper holder on the electric fan housing...
8.... then remove both tubes of the heat exchanger from the lower holder.
9. Remove the two bolts securing the tube of the power steering system to the lower cross member of the radiator frame (shown with radiator diffuser removed for clarity).
10. Tie the radiator of the cooling system to the upper cross member of the radiator frame, then unscrew the two bolts securing the lower cross member of the radiator frame...
11.... remove the bolts...
12.... and remove the cross member.
NOTE: If the rubber pads on the lower radiator mounts are badly compressed, hardened, or torn, replace them.
13. Press the latches of the fan shroud mounting brackets and, releasing the latches first on one side and then on the other...
14.... remove the electric fan assembly with the casing.
15. Establish the electric fan of a radiator of system of cooling with a casing in an order, the return to removal.