Contents: Removal ↧ Installation ↧
Removal
1. Disconnect the brake pipes from the limiting valves.
2. Remove the valves from the master cylinder body.
Installation
Note: Since these valves are adjusted in pairs to the appropriate control range, they must be replaced in pairs.
1. Install the limiting valves on the master cylinder body and tighten the limiting valves to a torque of 35-44 Nm.
2. Connect the brake pipes to the limiting valves and tighten to a torque of 16 Nm.
3. Raise and secure the vehicle securely.
4. Remove air from the brake system.
The original source of the article is the website: «CHEVYMAN.ru»