Contents: Removal ↧ Installation ↧
Removal
1. Raise and secure the vehicle securely.
2. Mark the position of the front wheels relative to the hubs and remove the wheels.
3. Remove the bolt and washers securing the hose to the brake caliper.
4. Disconnect the brake hose and plug the holes in the bracket and brake hose to prevent fluid leakage and dirt from getting inside.
5. Remove the bolts securing the bracket to the steering knuckle and remove the bracket.
Installation
1. Install the bracket and tighten the caliper mounting bolts to the steering knuckle to a torque of 95 Nm.
2. Connect the brake hose, tightening the fastening screw to a torque of 40 Nm.
3. Install the front wheels.
4. Lower the vehicle.
5. Fill the master cylinder to the appropriate level with clean brake fluid.
6. Bleed the bracket.
7. Recheck the fluid level. Note: Do not drive the car until the brake pedal is firm. Otherwise, it will cause improper braking.
8. Press the brake pedal again to bring the brake pads into contact with the brake disc.