1. Turn off the ignition (if it was turned on) and open the hood.
2. Loosen the nut securing the negative terminal tip by two or three turns...
3. ...and remove the wire from the negative terminal of the battery.
4. Open the protective cover of the positive terminal of the battery. Loosen the fastening nut of the positive terminal tip by two or three turns...
5. ...and disconnect the wire from the terminal.
6. Remove the battery mounting bracket bolt.
7. Remove the bracket.
8. Remove the battery from the engine compartment.
9. Install the battery in the reverse order of removal. Before connecting the wires, clean the battery terminals and the inner surfaces of the wire tips with fine-grained sandpaper. Connect the wires in the reverse order of removal, observing the polarity.
10. After connecting the wires to the terminals, apply a thin layer of special copper-containing conductive grease to the wire tips and exposed surfaces of the terminals.