The connections of the tubes with all brake system components and hoses, as well as the principles of their replacement, are the same.
NOTE: The work is shown using the example of the tube connecting the rear wheel working cylinder to the rear brake hose. The other tubes are removed in almost the same way, the only difference is in the places where their holders are attached to the body.
1. For ease of work, remove the rear wheel from the side of the tube being replaced.
2. Loosen the nut securing the brake pipe tip to the brake hose tip on the rear suspension beam arm bracket...
3. ...and disconnect the tube from the hose.
4. Unscrew the nut securing the brake pipe to the working cylinder...
5. ...slide the nut along the pipeline, disconnect the tube...
6. ...and take it off.
7. Install the new tube in the reverse order of removal.
8. After replacing the tube, bleed the air from the brake system (see "Bleeding the hydraulic brake system").