1. Remove the engine crankcase guard (see "Removal and installation mudguards and engine crankcase protection").
2. Place a jack or support under the engine crankcase.
3. Remove the air filter housing (see "Removal and installation the air filter and air duct").
4. Unscrew the bolt...
5. ...and unscrew the two nuts securing the support to the body side member.
6. Remove the three bolts securing the support to the engine bracket...
7. ...and remove the support.
8. Inspect the support cushion. If there is swelling, cracking of the rubber mass, its separation from the metal collar, or cracks appearing in the collar, replace the support assembly.
9. If it is necessary to remove the support bracket from the engine, unscrew the bolt securing the power steering pipe holder to the bracket.
10. Remove the three bolts securing the bracket to the engine (the third bolt is not visible in the photo).
11. Remove the bracket.
12. Install the bracket and the right support of the power unit suspension in the reverse order of removal.
(The original article can be found on the resource «CHEVYMAN.ru»)