To check the correct adjustment of the parking brake drive, lift the drive lever up to the stop, and you should hear 8 or 9 clicks of the ratchet device. If the number of clicks does not correspond to the specified values, or the car is not held by the parking brake (see "Checking the parking brake"), adjust the drive. The parking brake drive adjustment unit is located in the passenger compartment under the floor tunnel trim.
1. Check the correct adjustment of the clearances between the brake shoes and the rear wheel brake drums. To do this, press the brake pedal hard several times with the parking brake lever lowered all the way down.
2. In the car interior, pry up the edge of the hole plug located in the bottom of the cup holders made in the floor tunnel lining.
3. Press one of the spring-loaded cup holder holders...
4. ...and remove the plug.
5. Raise the parking brake lever 4 clicks.
6. Tighten the adjusting nut on the end of the front parking brake cable until the rear wheels are fully braked.
7. Lower the parking brake lever and check the ease of rotation of the rear wheels. If rotation is difficult, slightly loosen the adjusting nut.
8. Place the car on its wheels.
9. Install the plug into the floor tunnel lining.